austin1125
Member
Hello all,
I have an Exo Terra terrarium and for the last month have had to shop vac it twice a day everyday to act as “drainage”. This obviously wasn’t my permanent plan for drainage but I have not had the time to properly set up or figure what I’m going to do as my long term solution. I have the day off tomorrow and Monday so I was going to take the whole day and clean out the enclosure and set up the drainage system. The only problem I have is I have no idea what I’m going to do hahaha. I have looked on the forums obviously for pictures and ideas but all of the posts have been older and the photos are no longer visible... The internet isn’t being much help either. If anyone could recommend anything or give me some ideas that I haven’t thought of I would be forever grateful. The last thing I want to do is drill through the bottom which is non-tempered glass but that’s what it’s looking like is going to happen at this point. I bought a diamond- plated core drill bit and the rubber ring to keep the glass wet whilst drilling and have watched an unearthly amount of tutorial drilling videos but I would hate to shatter the thing as it was expensive. Thank you in advance!
I have an Exo Terra terrarium and for the last month have had to shop vac it twice a day everyday to act as “drainage”. This obviously wasn’t my permanent plan for drainage but I have not had the time to properly set up or figure what I’m going to do as my long term solution. I have the day off tomorrow and Monday so I was going to take the whole day and clean out the enclosure and set up the drainage system. The only problem I have is I have no idea what I’m going to do hahaha. I have looked on the forums obviously for pictures and ideas but all of the posts have been older and the photos are no longer visible... The internet isn’t being much help either. If anyone could recommend anything or give me some ideas that I haven’t thought of I would be forever grateful. The last thing I want to do is drill through the bottom which is non-tempered glass but that’s what it’s looking like is going to happen at this point. I bought a diamond- plated core drill bit and the rubber ring to keep the glass wet whilst drilling and have watched an unearthly amount of tutorial drilling videos but I would hate to shatter the thing as it was expensive. Thank you in advance!